Treedix 20pcs SW-520D Metal Ball Tilt Shaking Position Switch Vibration Sensor Switch Compatible with Arduino

Specification: Operating Characteristics: 1.When the switch is in the stationary state, as shown in (ON) below the level of the end of 15 degrees, the switch is in the ON state; 2.When (OFF) side below the level of 15 degrees, the switch is in OFF state; 3.When subjected to external shaking forces and shaking reached, or when the conduction angle is set in the range, the conductive pin electrical characteristics will produce short or continuous conduction 4.When the switch is OFF side angle of 15 degrees below the horizontal, while shaking difficult to trigger conduction; 5.The trigger switch for low current circuit, does not apply when the power switch; 6.,This switch is a sealed package, dustproof, waterproof; 7.When you want to restore the electrical characteristics of the open state (OFF), switch to set the environment must be static, and (OFF) below the level required to set up the open end angle; Package Including 20 pack SW-520D Metal Ball Tilt Shaking Position Switch Ball switch is also called steel ball switch and bead switch. In fact, they are all vibrating switches, but they are different in terms of the principle of ball rolling contact guide needle to control the switch on or off of the circuit. Simply put, just like turning on or off the lamp, when the switch touches the metal plate inside, the lamp turns on and off, and the ball switch uses similar principles. By rolling the beads in the switch, making contact with metal terminals or changing the route of light, the effect of conduction or non-conduction can be produced. There are many different types of ball switches, including angle induction switch, vibration induction switch, centrifugal force induction switch and photoelectric ball switch. In the near future, the ball switch will be one of the main products in the connector. It is also suitable for

• Detecting orientation or inclination.
• Equivalent to a pushbutton activated through its physical orientation.
• Containing a metallic ball inside that will commute the two pins of the device from CLOSED to OPEN if the sensor exceeds a certain angle and viceversa.
• Max voltage : 12V. Max Current : 20mA.
• Metal ball Tilt Switch Shaking Switch Position Switch The switch would be in the "off position" in the horizontal positon, "on positon" when raised to 10-90 degree or shakes Metal ball inside replace the mercury safer and non-toxic!